Bumper Repair their own hands

by umer | 7:56 AM in , , |

Bumper Repair their own hands
Quite often there are minor accidents, which usually suffers bumper, in connection with what is proposed and the post-read. All work carried out in the usual and ordinary garage, available materials and tools. For our example, used Mitsubishi Lancer car bumper 9. 
recalls that article does not claim to truth and is advisory in nature, listening to you, you will get the desired result.
So, let's begin.
Bumper unscrewed, conveniently laid and the first thing we need is as close as possible to dock the "fragments". For this you can use the clamp. Naturally character chips will be different, in this case, a sufficient stubtsiny on the edge of the edge. On the inner side seam propaivaem usual (60 W) soldering iron.
As armaturki use staples. Solder them at a distance of 3 mm and fused seam

From the outside, on the seam, remove the paint "orbitalkoy." P240 range







Produce solder outside in the same sequence

Thoroughly purged the whole thing with compressed air. Then take a hair dryer and podplavlyaem villi formed on plastic
We clean soldered and cooled =) seam, around the same grit (P240)

Next, the course is filler for plastic!
Nameshivaem, and we put a rubber spatula, because enough surface relief.



In places trudnostupnyh spatula serves finger ;)
Sushim.
sanding putty round P120.
Under ground change circle on P240.



Direct the soil in the proportion of 3 to 1 (according to the instructions). Gruntuem in 2 layers with intermediate drying of 15 minutes

Next we put the developing layer.
As a developer using the base color of cherries, or any other dark for light soil

Sushim 30 minutes infrokrasny drying.
Zateraem developing layer first P800, finish - P1000
Remained not derived bong, not seen on the putty. To eliminate it take nitroshpatlevku
Remained not derived bong, not seen on the putty. To eliminate it take nitroshpatlevku

 
Degreasing. Wipe sticky dust cloth.

  

We put on a primed base portion, not Focusing on the ground (ie, each successive layer overlaps predyduzhy 5-10 cm). In our case lacked three layers (2 - "luster", 1 - "dry").
After exposure to 20-30 min., Harboring all the detail painted in 2 layers. Done.